Reply
Contributor

Re: UNSUCCESFULL SPEED TIMING CALIBRATION

sorry for bordering... there was a bad pin at timming calibration signal in the ECM conector... we fixed it and calibration is done...

thank you very much anyway!!!

Super Contributor

Re: UNSUCCESFULL SPEED TIMING CALIBRATION

What are you working on? Need genset serial number.
Highlighted
Contributor
Accepted Solution

UNSUCCESFULL SPEED TIMING CALIBRATION

 Hi! Like always, first of all, sorry about my english...

I am experiencing an issue with a speed & timming calibration. The fact is that I have some calibrations done before without major drawbacks, however, in this case, the result has been an unsatisfactory calibration message, with a permanent EMCP active diagnostic code.
The machine is being governed by an EASYGEN 3200 energy manager, so it was necessary to disable a number of protections to prevent shutdown while speed decreases to 800 RPM. configured the necessary parameters, it repeatedly tried the calibration procedure without success.
any clue?
thanks for your time.