11-01-2018 03:48 PM
BOA TARDE AMIGO TIVE O MESMO PROBRLEMA EM QUATRO MPD CAT MOTOR C9 ACERT , LEVEI OS QUATRO DISPLAY E COLOQUEI EM OUTRO MOTOR , APARECEU O MESMO PROBLEMA COM OS DISPLAY, ESTOU TENTANDO REPARAR OS DISPLAY É CERTEZA QUE A AVARIA É NO DISPLAY
09-15-2018 10:09 AM
Will the port engine start ? If the Port engine ECM is not recieving power then it can not communicate with the MPD Panel and will bring up the loss of communication messages on the MPD
09-11-2018 08:25 PM
08-05-2017 02:04 AM
Harry when you will get this solution,please advise me how you done it,or send me email on...firstname.lastname@example.org, I will appriciate.
04-27-2015 01:02 AM
Hi guys hopefully someone will be able to provide me with a solution for my problems.
Following the shut off of the panel and batteries on the port main engine to replace the secondary fuel filters, upon turning back on, the following errors appear on the display panel.
-J1939 DATA Communications Loss
-J1587 (ATA) DATA Communications Loss
-Also the Overspeed shutdown light is lit (As shown in attached picture)
Even if the panel is switched off again and battery switch off the errors re-appear when switching back on.
When comparing to the Stbd main engine panel I also noticed the following differences.
-There are 4 less relays lit up inside on the port panel. (Pictures attached show this)
-The Secondary ECM ready light is not lit up on the port but is on the starboard
-There is not battery voltage reading on the display panel.