04-02-2018 09:59 PM
Yes, that is correct both the old p/n have been replaced with the two new p/n you have indicated. The article states that if you have the old p/n, they should work okay. The new p/n has several improvements for the newer engine controls.
04-02-2018 09:13 PM
Last month, I ordered diagnostic tool group with P/N 466-6258 with Communication Adapter P/N 317-7485 included.
However our dealer said that the tool group has replaced P/N 466-6258 and P/N317-7485 to 538-5051 and 478-0235, respectively.
Is this information correct?
01-06-2018 05:11 PM
The 317-7485 communicator adatpter 3 will work on all Cat gas engines that are electronically controlled, including the G3600 A4. On some of the later gas engine models, you can input limited information through the remote panel using the keypad or buttons. However, in order to perform calibrations or setup procedures, you will need a laptop, the Comm Adapter 3 with connecting cables, and a copy of Electronic Technician (ET) installed on the laptop and licensed by a Cat dealer. The ET software will open but it will not fully perform without being licensed by Cat. Cat ET will work on all Cat gas engines with electronic controls for communication to the engine ECM.
01-06-2018 11:33 AM
01-05-2018 09:14 AM
Good morning, I have a query the communicator adatpter 3 - 317-7485 is used to communicate with CAT 3608 ADEM4 or should I have another model, if so, could you advise me what should it be? What can I do with this communicator to serve me? From already thank you very much.