05-14-2018 11:31 AM
Did you ever get a copy of the CCM software? I'm in a spot where my original disk is no longer readable and the hard drive died on the monitoring computer. Any help would be greatly appreciated..
02-26-2010 10:51 AM
Hello, I am having the same kind of problem, I want to connect de ECM to an existing SCADA system I have the G3516 Gas engine; the specification sheet says it has the PL1000. So when I look inside the control box I can see that it has 4 cables connected to the 70pin terminal (2,3,8,9) then on the connector where I hook the 1708CAB9 connector cable it has the E,F,A,B pins.
I have all connected and I have identified the 8,9 pins are the communications pins for data transfer but my problem is that I receive this info and I don’t know how to interpret it because I haven’t been able to identify the protocol the system is using. So it will be a lot of help if anybody could tell me which one is using.
Anybody can help me please.
11-11-2009 06:31 AM
11-11-2009 06:27 AM
CCM already installed on 6 gensets model G3520 C hooked up on step up transformers,our state reguralator as per power purchase agreement needs annual capacity testing,we needed to show eKW,KVAR,KVA,KWh,KVARh,% of rated load and power factor.These data has to be pullout from CCM not from the transformer because of magnetic loses.Do we need a software?
11-09-2009 03:58 AM
Interface of CAT engines is possible on a customised scada system by usage of the old version CCM if you have them installed on your engine at factory and you can cut a great cost. Other wise if it is not available on your engine, it is advisable to install PL1000 E.
If you can provide the following information I will be happy to provide you with information:
10-14-2009 11:27 PM
What type of informaion you required ?
CAT has launched new PL1000T Communication ECM which can be hooked up with your exisiting SCADA and monitoring of Engine parameters are possible now.
09-25-2009 05:23 AM